Print Page | Close Window

Mustang Paintkit

Printed From: Citation Mustang Forum
Category: Citation Mustang Xperience Forums
Forum Name: Citation Mustang General Forum
Forum Description: General non-support questions for the Citation Mustang.
URL: http://mustang.flight1.net/forums/forum_posts.asp?TID=4771
Printed Date: Aug-19-2019 at 4:19am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: Mustang Paintkit
Posted By: Flying Dutchman
Subject: Mustang Paintkit
Date Posted: Jan-18-2019 at 7:48am
I'm just about to start pulling out my hair.

Done a new paint project, and follow the finished paint instructions.
However, I cannot select the first 1024x1024 square on the background section
using the Magic Wand Tool, because it highlights the entire 7 squares.

When I merge copy, then paste (on the new square) a copy of the new paint
the first square appears.

The problem I have, I can't after that select any of the remaining squares of
the new paint job.

The instructions I'm afraid are not very clear to me.

If I use the rectangular marquee tool I can select all 7 squares individually
and save them as dds files.

However if I do this then although I can look into the cockpit windows from the
outside, when I place myself inside the cockpit the windows are blank and I can't
look out.

Maybe Jeff Smith can give me some idea where I'm going wrong.

  Thanks in advance for any help.



-------------
With regards, Jaap



Replies:
Posted By: Zjulik
Date Posted: Jan-18-2019 at 12:43pm
Check Select continuous?


Posted By: Flying Dutchman
Date Posted: Jan-18-2019 at 3:07pm

  Thanks for your reply Zjulik,
I sorted the problem, it was not what you mentioned.
I found it was easiest to select the squares 1 to 7 with the
magic wand tool if I deselected layers base layer to shade layer,
then make the selection and reselect the layers again before
the copy and paste process on a new 1024x1024 square.
That solved it for me.


-------------
With regards, Jaap


Posted By: N510CE
Date Posted: Jan-18-2019 at 4:30pm
Can't wait to see your new project flying Dutchman 


Posted By: Flying Dutchman
Date Posted: Jan-21-2019 at 8:10am

 Actually I was working on two projects N510CE, these are them finished.


-------------
With regards, Jaap


Posted By: N510CE
Date Posted: Jan-22-2019 at 11:23pm
Cool and will there be versions with American N numbers?


Posted By: Hiflight
Date Posted: Jul-26-2019 at 7:16pm
Hi, did the WiJet make it to public download?



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net